FONESTAR VS-2490HD Manual De Usuario página 3

OPERATING AND CONNECTION INSTRUCTIONS
The maximum distance between transmitter and receiver for a 1080p@60 Hz signal is 100 m under optimal
conditions and direct view.
This maximum distance may be affected if there are interferences from other Wi-Fi signals in the area, if the
source's HDMI signal is low, or if the cables used are of poor quality and/or too long.
It is recommended to use quality HDMI cables and of the lowest length possible.
CONNEXIONS
1.- Connect the supplied antennas to the transmitter and receiver.
2.- Connect the HDMI cable between the transmitting device and your video source (Blu-Ray, DVD, PC,
etc.).
3.- Connect the HDMI cable between the receiving device and your monitor.
4.- Turn on the video source and monitor.
5.- Place the plugs on the power adapters and connect them to both devices.
6.- Connect the receiver to the mains. Wait a few seconds until
without flashing.
7.- Connect the transmitter to the mains. The
The LINK indicator lights on both devices inform you of the status of the pairing and the HDMI signal to
be displayed as shown in the following table:
LINK
(transmitter) (receiver)
power on power on
flashing power on
flashing flashing
8.- OPTIONAL - remote control extender. Connect the IR accessories as follows to allow you to control
the source with your remote control from the VS-2490HD receiver position . Connect the IR receiver
(rectangular shape) to the IR IN input of the VS-2490HD receiver and the IR transmitter (round shape)
to the IR OUT output of the VS-2490HD transmitter.
Place the IR receiver in a location with direct vision to aim the remote control. And the IR transmitter in
front of the source IR receiver (usually integrated into the device's front panel).
1
LINK
Transmitter and receiver ARE linked to each other, but there is no HDMI signal.
To link them, refer to LINKING TRANSMITTER AND RECEIVER
Transmitter and receiver ARE linked to each other and there is HDMI signal
1
2
2
LED indicator will come on at this time.
Description
Transmitter and receiver are NOT linked to each other
- 3 -
¡¡ CLICK !!
and LINK LED indicators remain on
EN