Levenhuk Ermenrich Zing AL45 Guia Del Usuario página 3

Ermenrich Zing AL45 Battery Tester
EN
Please carefully read the safety instructions and the user manual before using this product. Keep away from children. Use the
device only as specified in the user manual.
Note!
This device is designed for testing 12V batteries only. Do not use it on a group of batteries connected in series.
Usage
•
Turn the ignition and all of the accessories off half an hour before testing the battery. Remove any dirt and grease from the battery
terminals.
•
Put the clamps on the battery terminals according to their corresponding polarity: the red clamp goes on the positive (+) terminal and the
black clamp goes on the negative (–) one.
•
Press the power button to turn the device on. The numbers on the screen will start flashing and a beeping sound will be emitted.
•
Press OK to enter the CCA (Cold Cranking Amps) value indicated on the battery. Press UP or DOWN to change the digit, and then press
SEL to move to the next digit to change it. Press OK to start the battery testing.
•
Press any button to silence the beeping sound. Press the power button to turn the device off.
•
When the low battery icon (
Display information
•
When the battery testing is done, the first row of digits will show the voltage of the battery and the second row of digits will show the
resistance of the battery in mΩ.
•
Press SEL to change the display view. Now, the first row of digits will show the CCA value that you entered. The second row of digits will
show the actual tested CCA value.
•
The battery capacity graph shows the percentage of the battery's working capacity.
40 to 60%
The battery is old; consider replacing it.
Specifications
Application
Voltage measurement range (DC), V
CCA test
Battery level test
Testing standards
Operating temperature range, °C/°F
Power supply
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.
Care and maintenance
Only use the device within the permitted range. Do not use the device if it is not working properly. Protect the device from sudden impact
and excessive mechanical force. Store the device in a dry cool place. Please note that the parameters of the power supply must comply with
the technical characteristics of the device. Do not smoke, cause sparks, or strike matches near the battery when testing. Do not come in
contact with a leaking battery. If battery acid comes into contact with your skin or clothing, wash it off immediately with soap and water. If
acid comes into contact with your eyes, flush immediately with copious cold water for at least ten minutes and get medical attention as soon
as possible. Keep away from children.
Levenhuk International Lifetime Warranty
All Levenhuk telescopes, microscopes, binoculars, and other optical products, except for their accessories, carry a lifetime warranty
against defects in materials and workmanship. A lifetime warranty is a guarantee on the lifetime of the product on the market. All Levenhuk
accessories are warranted to be free of defects in materials and workmanship for six months from the purchase date. The warranty entitles
you to the free repair or replacement of the Levenhuk product in any country where a Levenhuk office is located if all the warranty conditions
are met.
For further details, please visit: www.levenhuk.com/warranty
If warranty problems arise, or if you need assistance in using your product, contact the local Levenhuk branch.
) appears on the screen, please recharge the battery and carry out the testing once again.
60 to 80%
The battery is in working condition.
12V starter battery
7–15
+
+
CCA
0...+50 (operating), −10...+50 (storage) / +32...+122 (operating), +14...+122
(storage)
from the tested battery
3
80 to 100%
The battery is in good condition.