Use - Drying - Electrolux EWX127410W Manual De Instrucciones

12 electrolux
INTERRUPTING A PROGRAMME
Press the button 8 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
CANCELLING A PROGRAMME
Turn the selector dial to
gramme which is running.
You can select now a new programme.
OPENING THE DOOR
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button 8.
After a few minutes the pilot light 9 goes
out and it is possible to open the door.
If this pilot light remains lit, this means that
the machine is already heating or that the
water level is too high. In any case, do not
try to force the door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to O. After a
few minutes the door can be opened (pay
attention to the water level and temper-
ature!).
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 8.
Stand by : once the programme has finish-
ed after a few minutes the energy saving
system will be enabled. The brightness of

USE - DRYING

DRYING ONLY
Warning!
The recommended load size is 3 kg for cot-
tons and line and 2 kg for synthetic items.
It is also possible to dry up to 4 kg of
cotton items (see the «Drying Pro-
gramme » table).
Warning!
The water tap must be open and the
drain hose must be positioned in the
sink or connected to the drain pipe.
to cancel a pro-
AT THE END OF THE PROGRAMME
The machine stops automatically. Three
blinking 0.00 appear on the display and the
pilot light of button 8 goes off. Some
acoustic signals sound.
If a programme or an option that ends with
water left in the tub has been selected, the
door remains locked to indicate that the
water must be emptied out before opening
the door.
Before you empty out the water, the drum
continues to run at regular intervals until the
water draining.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to O.
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 8.
At the end of the programme, the door is
released and can be opened. Turn the pro-
gramme selector dial to O to switch the
machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
the display is reduced. By pressing any but-
ton the appliance will come out of the ener-
gy saving status.
1. Load the laundry.
2. Select a spin cycle at the maximum
spin speed allowed for the type of laun-
dry in order to obtain the best drying
performances.
3. Select the drying programme for Cot-
tons or Synthetic in the Drying sector of
the programme selector dial.