Polar GG755 Manual De Instrucciones página 4

EN
Installation
Note: Not for use in vans or trailers, food
trucks or similar vehicles.
Note: If the unit has not been stored or
moved in an upright position, let it stand
upright for approximately 12 hours before
operation. If in doubt allow to stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance for the
first time, clean the interior with soapy
water then dry well.
Operation
• The appliance is designed for display
purpose only and not for storage.
• Remove any water that may be present
before and after use, using the drain
hose beneath the base.
Control panel
On/off switch
4
GG755_ML_A5_v1_20230316.indb 4 GG755_ML_A5_v1_20230316.indb 4
Refrigerant LED:
During refrigerating, LED is on; When
the set temperature is reached and
constant, LED is off.
Defrost LED:
During defrosting, LED is on; When
defrosting finishes, LED is off.
Up Button
Down Button
Manual defrost button/light button
SET
Set button
Turn On
1. Close the door of the appliance.
2. Connect the appliance to the mains power
supply.
3. Press On/off switch located on the rear.
Adjusting the Temperature
1. Press SET button. The set temperature is
displayed.
2. Press up button or down button
change the set temperature.
3. Press SET button to exit.
Internal light
Press the button on the controller to turn the
internal light on/off.
Manual Defrost
To start/stop manual defrost, press and hold
defrost button for 6 seconds.
to
2023/3/16 16:40 2023/3/16 16:40