Service Parts/Kits List; Troubleshooting - SKF TLGB 20 Instrucciones De Uso

Service parts/kits list

Item Description
1 Grease tube assembly
2 Flexible hose kit
2 1 Cap
2 2 Coupling
2 3 Flexible hose 36 in (914 mm) with gasket
3 Battery pack 20 V (lithium)
NS Battery charger (lithium) 220-240 volt
1)
NS Battery charger (lithium) 110 volt
NS Shoulder strap
1) Not shown

Troubleshooting

Condition
Grease gun fails to dispense grease
Display lashing red due to motor overload
Grease gun continues to lose prime
Battery fails to take a charge
Motor fails to run
Part number
TLGB 20-4
TLGB 20-3
TLGB 20-2
TLGB 20-5
TLGB 20-6
TLGB-20
Cause
Grease tube assembly is out of grease
Loss of prime
Ball check (16) is not functioning
Clogged whip hose
Blocked lube point
Clogged whip hose
Air trapped in several locations in container
after bulk illing
Follower binding in grease tube assembly
Check ball seat (16) and check ball dirty
No power to charger
Battery may be bad
Battery needs charging
Faulty wiring to motor
15
Qty
1
1
1
1
1
1
1
1
Corrective action
Check that grease tube assembly has grease
Repeat priming operation
Remove ball check (16), clean and inspect ball
seat area
Clean or replace whip hose Remove blockages
Clean or replace whip hose
Clean or replace whip hose
Empty grease tube assembly, reill and
repeat priming instructions
Disassemble grease tube assembly and clean
Be sure that follower has properly entered
grease cartridge
Disassemble grease tube assembly and clean
Be sure that follower has properly entered
grease cartridge
Verify that the follower is not caught on rim of
grease cartridge
Replace grease tube assembly (14) if damaged
Clean check ball (16) and check ball seat
Check that receptacle has power
Replace battery
Recharge battery
Remove battery, disassemble handle and
check wiring connections on terminal,
trigger switch and motor