Lifetime Air FT-30ME Manual De Instrucciones página 5

Attaching the fan head and motor assembly to the telescopic
stand.
1. Post
2. Pivot knob
3. Neck retaining screw
4. Motor housing
5. Small adjustment knob
6. Large pivot bolt
NOTE:
The illustration above shows the motor housing without the fan
head. On the fan model you purchased, the fan head is already
assembled to the motor housing.
1. First remove the pivot knob (2) and the large pivot bolt (6) from the top
of the post, then remove the neck retaining screw (3) and the small
adjustment knob (5) from the motor housing bracket.
2. Place the fan head and motor assembly on the top of the post and
thread the large pivot bolt (6) through the bracket. Screw in the neck
retaining screw (3) and tighten, but do not overtighten.
3. Fit the large pivot knob (2) onto the end of the bolt (6) and the small
adjustment knob (5) at the other side above the bolt. Tighten the knobs
while holding the fan motor upright.
CONTROL
1. Use the speed control button for the correct speed selection. There are
3 different speed levels. LOW(1)/MEDIUM(2)/HIGH(3).
2. To activate the oscillation function you can press (off) or pull (on) the
oscillation knob.