GreenWorks GD40AB Manual Del Operario página 5

EN
1 DESCRIPTION
1.1 PURPOSE
The machine is used to propel air out of a tube to move
unwanted materials such as leaves in the yard. Some
machines also suck in leaves and small twigs through a
vacuum, and shred them into a bag.
1.2 OVERVIEW
Figure 1-4.
1 Trigger
2 Turbo button
3 Cruise control lever
4 Tube release button
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings, instructions, illustrations and
specifications provided with this power tool.Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3 INSTALLATION
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
5 Tube
6 Nozzle
7 Slot
8 Battery release button
WARNING
WARNING
WARNING
English
3.2 INSTALL THE TUBE
Figure 2.
1. Move the tube until the lock button engages into the slot.
2. Connect the nozzle to the tube until the latch on the tube
engages into the opening on the nozzle.
You can use the nozzle to increase airflow in tight areas.
3.3 INSTALL THE BATTERY PACK
Figure 3.
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.4 REMOVE THE BATTERY PACK
Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
Make sure the blower tube is in position before operation.
4.1 START THE MACHINE
Figure 4.
1. Pull the trigger to start the machine.
2. Pull the trigger fully to increase the speed.
3. Release the trigger to decrease the speed.
4.2 STOP THE MACHINE
1. Release the trigger to stop the machine.
Wait until the motor stops after you stop the machine.
4.3 CRUISE CONTROL LEVER
Figure 4.
4
TIP
WARNING
WARNING
NOTE