Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION!
If you need to remove the cable gland, remove it in the order (c), (b) and (a). If you do not follow this
reverse procedure, the cable will twist and consequently be damaged.
4.5.2 Connecting the Ethernet
NOTE!
If the selected power supply was via PoE, this step was already completed in the previous section,
since the PoE power supply occurs on the same ethernet cable over which the data is transmitted.
a
Remove the ETH/PoE silicone plug (M22 x 1.5) on the bottom, pass the Ethernet cable through the cable gland,
insert the RJ-45 connector into the Ethernet port of the X2000 and tighten the cable gland in the order (a), (b) and
(c). The torque in step (c) must be smaller than the torque in step (a).
ATTENTION!
If you need to remove the cable gland, remove it in the order (c), (b) and (a). If you do not follow this
reverse procedure, the cable will twist and consequently be damaged.
DC power adapter
a
b
c
a
b
c
b
Installation
c
Gateway Cassia X2000 | 19
Publicidad
