Publicidad
Idiomas disponibles
Idiomas disponibles
h)
To ensure the designed operational integrity of the device, do not remove
factory-installed covers or loosen screws.
i)
When transporting or moving the device from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the device is used.
j)
Avoid situations in which the device stops under heavy loads during operation.
This can cause overheating of the drive elements and consequent damage to
the equipment.
k)
Do not touch any moving parts or accessories unless the device is unplugged.
l)
Clean the device regularly to prevent permanent dirt build-up.
m) Do not process two workpieces at the same time.
n)
The product is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
o)
Do not tamper with the device to alter its performance or design.
p)
Keep the unit away from sources of fire and heat.
q)
Do not overload the device.
r)
Do not exceed the maximum permissible operating pressure of the unit!
s)
Do not block the ventilation openings of the unit!
t)
Report any leakage of operating oils from the machine to the relevant
authorities or comply with the legal requirements in your area of use.
u)
To be used for cutting steel reinforcing bars of a maximum 60 grade, not
higher. Do not use for cutting unclassified rebar.
v)
While cutting pieces shorter than 30 cm, there is a risk that the cut tip may
bounce off and injure the operator. Cutting materials outside of the acceptable
parameters increases this risk, so do not cut materials thicker or thinner or
harder than recommended.
w)
Never cut rebar immersed in wet concrete.
CAUTION! Although the product has been designed to be safe and
has adequate safeguards and despite the additional safety features
provided to the user, there is still a slight risk of accident or injury
when handling the product. Caution and common sense are advised
when using the product.
3. Instructions for use
The product is designed for cutting reinforcing bars, square rebars, smooth, ribbed
or square wires.
The user is responsible for any damage resulting from misuse.
Publicidad
