Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION: if the hydraulic fluid (oil) in the device heats up to 70
the performance of the device may drop, so care is advised when
working with the device, especially in the summer, when the pump
housing can get hot. In the event of the device becoming hotter, stop
working and resume it only after the device has cooled down.
ATTENTION: when the piston is blocked during its retraction, stop
working and check if there is any object under it that is blocking its
movement. If not, the piston can be manually inserted into the
housing by applying pressure to it with a rebar or a similar hard
element - never try to insert it with your hand, even in protective
gloves! You can also keep the trigger pressed when the piston is
extended until the piston has partially moved. If the piston does not
retract after cleaning its vicinity, it may be damaged.
3.4.
Cleaning and maintenance
a)
Clean the device after each work, preferably immediately after its completion.
b)
Pull the mains plug and let the unit cool down completely before cleaning,
adjusting or replacing accessories and when the unit is not in use.
c)
Use only non-corrosive cleaning agents for cleaning the surfaces.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the vents with a brush. Do not use compressed air because metal filings
can get into the eyes or the respiratory system!
h)
Perform regular inspections of the unit checking technical fitness and any
damages.
i)
Use a soft cloth for cleaning.
j)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as they may damage the surface of the appliance material.
k)
After 500 cuts, check the tightness of the cutting jaw screws.
l)
After 500 cuts or once a week assuming regular use, check the tightness of all
the housing screws, especially those securing the cylinder housing.
m) After 1000 cuts, the cutting jaws should be turned over or replaced with new
ones if their ends are worn or broken. To replace them, unscrew the 2 screws
securing the given jaw.
n)
Every 2 months or after 500 cuts, check the condition of the motor's carbon
brushes. The condition of the carbon brushes should also be checked when the
motor of the device is getting weaker and heats up. Regular inspection and
C,
o
Publicidad
