Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. E
Loading the Tool (Fig. F–H)
NOTICE: Use only pins recommended for use in your
pin nailer which meet the BOSTITCH specifications.
Refer to Pin specifications.
1. Depress the magazine release lever
2. Pull sliding portion of magazine
Fig. F
5
6
3. Load the stick of pins with the arrow pattern pointing
down as shown. If pins have black dots instead of
arrows, the dots should be positioned up.
Fig. G
4. Close magazine until it latches. The tool is now ready
for use.
1
Trigger Operation with a Secondary
Trigger (Fig. I)
.
5
back.
6
The tool will actuate each time the primary trigger
the valve is pulled until the secondary trigger
hand grip is released. This trigger operated tool is operated
by first pulling or grasping the secondary trigger under the
hand grip, followed by pulling the primary trigger under the
valve as shown.
Belt Hook (Fig. J)
Fig. H
6
WARNING: Never inadvertently pull or grasp the
secondary trigger when moving about, changing
work location, when holstering or hanging tool, or
when preparing work surface for fastening operation.
WARNING: The operator must not hold the secondary
trigger pulled except during fastening operation as
serious injury could result if the trigger accidentally
contacts someone or something, causing the tool
to cycle.
Fig. I
2
3
WARNING: Remove pins from magazine before
making any adjustments or servicing this tool. Failure
to do so may result in serious injury.
WARNING: Disconnect the air supply from tool before
making any adjustments, changing accessories,
servicing, or moving the tool. Such preventative
safety measures reduce the risk of actuating the
tool accidentally.
English
under
2
under the
3
5
Publicidad
