Publicidad
Idiomas disponibles
Idiomas disponibles
LCD DOOR CONTROL
SYNCHRONIZE THE DOOR CONTROL
To synchronize the door control to the garage door opener, press the push bar until
the garage door opener activates (it may take up to 3 presses). Test the door
control by pressing the push bar, each press of the push bar will activate the
garage door opener.
USING THE LCD DOOR CONTROL
Push Bar
Navigation
Buttons
LIGHT Button
PUSH BAR
Press the push bar to open or close the door.
LIGHT BUTTON
Press the LIGHT button to turn the garage door opener lights on or off. When the
lights are turned on they will stay on until the LIGHT button is pressed again, or
until the garage door opener is activated. Once the garage door opener is
activated the lights will turn off after the specified period of time (the factory
setting is 4-1/2 minutes). The LIGHT button will not control the lights when the
door is in motion.
NAVIGATION BUTTONS
Use the navigation buttons to make selections and program features.
SCREEN
The screen will display the time and temperature until the menu button is
pressed, and then it will display the menu options. If there is a problem with the
garage door opener the screen will display the Diagnostic Code. Refer to the
Troubleshooting section.
The following features are accessible through the screen using the navigation
buttons on the LCD Door Control:
LEARN A DEVICE
Any compatible remote controls, wireless keyless entry, or myQ
be programmed to the garage door opener by accessing the menu and using the
navigation buttons on the LCD Door Control.
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from
remote controls while still allowing activation from the door control and keyless
Screen
entry. This feature is useful for added peace of mind when the home is empty (i.e.
vacation).
TIMER-TO-CLOSE (TTC)
Motion
Sensor
DO NOT enable TTC if operating a one-piece door. TTC is to be used ONLY with
sectional doors.
Factory default is set to off. TTC can be set to automatically close your garage
door from the fully open position after a specified period of time (1, 5, 10 minute
intervals). The LCD Door Control also has a custom setting up to 99 minutes. The
garage door opener will beep and the lights will flash before closing the door. The
screen on the door control will display the status of the TTC such as time to
close, paused, or an error. If the door encounters an obstruction while closing, the
garage door opener will make a second attempt to close the door. If the
obstruction has not been cleared after the second attempt, the garage door opener
will reverse open, stop and WILL NOT close until the obstruction has been
cleared. TTC WILL NOT work if the garage door opener is operating by battery
power or if the safety reversing sensors are misaligned. This feature is NOT
intended to be the primary method of closing the door. A keyless entry should be
installed in the event of an accidental lock out when using this feature.
AUTOMATIC LIGHT
Motion Sensor
Factory default is set to on. This feature will automatically turn on the garage door
opener lights when motion is sensed. The lights will come on for the set period of
time, then shut off.
If using the garage door opener light as a work light disable the Automatic Light
Feature, otherwise the light will turn off automatically if you are beyond the range
of the sensor.
Light Feature
The lights will turn on when someone enters through the open garage door and the
safety reversing sensor infrared beam is broken.
35
®
accessories can
Publicidad
