Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
To prevent accidental starting, do not make any
adjustments or installations with the battery pack
inserted. Accidental starting of the snow blower during
assembly could result in serious personal injury.
UNFOLDING AND ADJUSTING HANDLE
ASSEMBLY
See Figures 2 - 3.
NOTICE:
Do not allow the starter cable to become pinched or
trapped when raising the handles.
To raise intermediate handle:
Pull the handle adjustment knobs out and rotate 90 de-
grees.
Raise the intermediate handle.
Rotate the knob 90 degrees again to secure handle in
place.
To raise upper handle:
Open the handle lock clips.
Fully extend the upper handle.
Close the handle lock clips to secure the upper handle
in place.
ASSEMBLY
INSTALLING CHUTE ROTATION LEVER
See Figures 4 - 5.
Insert the end of the chute rotation lever lower rod into
the hole in the snow blower housing until it is fully seated.
NOTE: The opening on the back of the snow blower
housing is keyed to match the end of the chute rotation
lever bottom rod. Make sure to orient the rod in the same
direction as the keyed hole when installing the lever.
Slide the upper rod of the chute rotation lever through
the bracket on the handle.
Insert the upper rod into the opening at the top of the
lower rod. Align the holes in the two parts of the lever
and insert the hitch pin through the holes as shown to
secure.
Turn the lever left and right to verify the proper functioning
of the lever and the chute.
8 — English
Publicidad
