Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Thread a mounting nut to the bottom
of the valve. Place a washer and gasket
as shown.
NOTE: the hot water valve has a red
marking on side of body.
2.
Pass the valve up through the
installation hole.
Insert the gasket and fasten the
collar to the valve body until it
stops.
3.
Fixate the valve by threading the
mounting nut up the valve until hand
Gasket
tight. Tighten the retaining screws
equally to secure.
Washer
Do not overtighten!
Mounting
Nut
4.
Repeat steps 1-3 for remaining valve.
NOTE: Hoses to connect valve inlets to water supply lines not included.
5.
Place gasket under spout.
NOTE: If installing a Vivian model,
place the gasket under the décor
ring and place over mounting
hole.
Pass the supply hoses and
mounting stud through the
mounting hole until the spout
comes to rest.
INSTALLATION PROCEDURE - Valves
Gasket
Washer
Mounting
Collar
Gasket
INSTALLATION PROCEDURE - Spout
Nut
Mounting
Mounting
Screws
Screws
4
Gasket
Gasket
(Rubber)
(Rubber)
Washer
Washer
(Metal)
(Metal)
Mounting
Mounting
Nut
Nut
Collar
Collar
Gasket
Gasket
Spout*
Spout
Décor Ring
Base Ring
(Vivian models only)
(Vivian Models O
Gasket
Gasket
Moun
Scre
Publicidad
