Publicidad
Idiomas disponibles
Idiomas disponibles
7. OPERATION
a. INITIAL SETUP
1. Connect hand-piece(s) to power unit output connector(s).
2. Insert your selected cartridge into the hand-piece.
3. Push the cartridge all the way until it seats.
For TATC cartridges, align the flat side of the cartridge shaft with the opening in the
handle. Push in the cartridge until it seats. The cartridge is fully seated when the insertion
mark is flush with the handle. Do not push past this mark. Repeat for second cartridge.
4. Place hand-piece(s) into associated workstand(s).
5. Add distilled water to workstand sponge (sulfur free) if equipped.
6. Plug the power cord into a grounded wall socket of the rated input line voltage.
7. To turn the unit "ON", push the power switch. NOTE: Unit must be grounded, otherwise it will
not work. Unit will not work in an electrical network where an isolation transformer has been
used.
8. Select the desired output left, right, or simultaneous, using the output selector/command button.
The active output will display an animated box cursor ( ) to the left or right of the screen,
respectively, to indicate the active output.
b. REPLACING ALL TIP CARTRIDGES
1. Make sure the system is turned off.
2. Pull out the cartridge using the Cartridge Removal Pad (MX-CP1). NOTE: THE TIP
CARTRIDGE MAY BE HOT. DO NOT USE METAL TOOLS (PLIERS, ETC) TO REMOVE
CARTRIDGES!
3. Push a new cartridge into the handle.
4. Place hand-piece(s) into associated work stand(s).
5. Push the power switch "ON". The new cartridge will heat up to temperature quickly.
c. MX-PTZ OPERATION
1. Clean, and then tin tips well once heated.
2. Ensure tips contact all leads on device, either the bevel or straight
portion of the tip can be used. Use solder across the leads to create a
Thermal Bridge.
3. Squeeze tool. Wait for all leads to reflow.
4. Maintaining pressure, lift component.
d. MX-PTZ TIP ALIGNMENT
e. USER PROGRAMMABLE POWERSAVE MODE ADJUSTMENT
1. With the system in the Ready or Power Modes, press and hold the Output Selector/Command
Button for 3 seconds until the time flashes.
2. Release the Output Selector/Command Button.
3. Press the Output Selector/Command Button until the desired time is achieved. The time will
increment by 10 minutes with each press of the button.
4. Press and hold the Output Selector/Command button for 3 seconds to return to operation.
f. USER SELECTABLE POWER GRAPH
1. With the system in the Ready or Power Modes, press and hold the Output Selector/Command
Button for 3 seconds until the time flashes
10
Thermal Bridge
Publicidad
