Troy Lee Designs A3 Manual Del Propietário página 7

10
10. REMOVE BOTH PLASTIC BOLTS AS SHOWN IN FIG.10 TO REMOVE VISOR.
11. 3 POSITION VISOR ADJUSTMENT: WITH BOTH SIDE BOLTS AND WASHERS INSTALLED, ADJUST VISOR
HEIGHT BY LIGHTLY PUSHING UP OR DOWN UNTIL THE VISOR CLICKS INTO ON OF THE THREE (3) POSITIONS
AS SHOWN IN FIG.11.
12. OPTIONAL GOGGLE STOWAGE POSITION: LIGHTLY PUSH THE VISOR UP PAST THE LAST DETENT TO ALLOW
ROOM FOR STOWAGE.
CHECK THE FIT: BEFORE USING THE HELMET, MAKE SURE THAT IT FITS CORRECTLY, IT IS POSITIONED TO COVER YOUR ENTIRE
FOREHEAD, THE STRAPS ARE CORRECTLY ADJUSTED, AND THE CHIN STRAP IS TIGHT. GRAB THE HELMET WITH BOTH HANDS
AND TWIST IT TO THE LEFT AND RIGHT. IF THE HELMET FITS CORRECTLY, THE SKIN ON YOUR FOREHEAD WILL MOVE AS THE
HELMET MOVES. IF THE SKIN ON YOUR FOREHEAD DOES NOT MOVE, THE HELMET IS TOO LOOSE.
CHECK THE STRAPS: WITH THE HELMET ON AND THE CHIN STRAP BUCKLED, GRAB THE HELMET WITH BOTH HANDS AND
TRY TO REMOVE IT BY ROLLING THE HELMET FORWARD AND BACKWARD AS FAR AS YOU CAN. MAKE A SERIOUS EFFORT. IF
YOU CAN ROLL/PUSH THE HELMET OFF THE HEAD COMPLETELY IN EITHER DIRECTION OR ROLL IT FORWARD SO FAR THAT
IT BLOCKS VISION OR BACKWARDS SO FAR THAT IT EXPOSES THE FOREHEAD, YOUR HELMET DOES NOT FIT CORRECTLY.
REPEAT STEPS ABOVE UNTIL HELMET MOVEMENT IS MINIMAL.
12
11
EN