6. Within 1.5 meters from lamps.
7. Next to doors or windows.
8. In the top of rooms with sloping roofs, the corner of the room or other dead-air spaces.
Mounting the smoke detector
1. Twist off the mounting bracket from the smoke detector.
2. Put the bracket on the installation position and mark the 2 screw holes.
3. Drill two 5mm mounting holes and insert two plastic anchor plugs by hammer.
4. Screw the mounting bracket to the ceiling or the wall.
5. Attach the smoke detector to the mounting bracket and turn clockwise to lock the alarm.
CAUTION:
1. The installation instructions must be followed strictly to avoid unsafe conditions.
2. Do not paint your smoke detector.
3. The battery cannot be replaced; do not try to replace the battery.
Activate and deactivate the device
The device is deactivated by default before leaving the factory. Before the device can be used normally, the product
must be activated.
Activate: Press the test button over 10 seconds until the red LED indicator lights up. After you release the test button the
smoke detector is activated and can be used.
Deactivate: Press the test button over 10 seconds until the red LED indicator blinks twice. After you release the test
button the smoke detector is deactivated and cannot be used.
Test your alarm
Test the unit to ensure proper operation by pressing the cover. The alarm will sound if the unit is working well. If there
is no sound, refer to the "Trouble shooting" section.
06