Miniland thermotalk plus 89068 Manual Del Usuario página 39

The device is intended for use in the electromagnetic environment specified below. The customer or
the user of device should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
The device is intended for use in the electromagnetic environment specified below. The customer or
the user of device should assure that it is used in such an environment.
IEC 60601test
Immunity test
Electrostatic ±8 kV contact
discharge (ESD) ±2 kV, ±4 kV, ±8
IEC 61000-4-2 kV, ±15 kV air
Electrical fast power supply
transient/burst lines ± 1 kV for
IEC 61000-4-4
± 0.5kV, ± 1 kV
Surge line(s) to lines
IEC 61000-4-5 ± 0.5kV, ± 1 kV,
± 2 kV line(s) to
Declaration - electromagnetic emission
Compliance
Group 1
Class B
Not applicable
Not applicable
Declaration - electromagnetic immunity
Compliance
level
±8 kV contact
±2 kV, ±4 kV, ±8
kV, ±15 kV air
± 2 kV for
Not applicable
input/output
lines
Not applicable
earth
Electromagnetic environment - guidance
The device uses RF energy only for its internal
function. Therefore, its RF emissions are very
low and are not likely to cause any interference in
nearby electronic equipment.
The device is suitable for domestic establishment
and in establishment directly connected to the
public low-voltage power supply network that
supplies buildings used for domestic purposes.
Electromagnetic environment -
level
Floors should be wood, concrete or
ceramic tie. If floors are covered with
synthetic material, the relative humidity
should be at least 30%.
Mains power quality should be that
of a typical commercial or hospital
environment.
Mains power quality should be that
of a typical commercial or hospital
environment.
39
guidance