Southland SEA528T Manual Del Operador página 6

Assembly
(Continued)
• Save all instructions
A
To Assemble Auger Bit
1 . Insert the shaft of a large phillips screwdriver into the
cross hole in the adapter .
2 . Hand tighten the Fishtail Point into the opposite end of
the adapter . Avoid contact with the Earth Blade and
cutting edge of the Fishtail Point .
B
To Assemble Auger Bit to Powerhead
1 . Move the On/Off Switch to the off position .
2 . Remove thwe Spark Plug boot from the Spark Plug and
secure the boot away from the engine and frame .
3 . Insert the Powerhead output shaft into the auger bit
adapter and align the top hole of the auger bit to the
hole at the output shaft .
C
To Assemble Handles
1 . Insert handle with throttle hole on fuel tank side . Attach
using 4 bolts, and nuts .
2 . Route throttle cable below saddle, and attach throttle
lever to handle using Phillips head screw driver .
3 . Zip tie throttle cable using provided zip tips .
4 . Attach remaining handle using 4 bolts, and nuts .
Questions? Call Toll Free at 1-800-737-2112
3 . Grip the side of the Fishtail Point with an adjustable
wrench and tighten while holding the phillips screwdriver
to secure the auger bit from rotating .
4 . Insert the bolt thru the hole in the Adapter and
Powerhead shaft .
5 . Install locknut and tighten with wrenches provided .
6 . Reinstall the Spark Plug boot onto the Spark Plug .
EN - 6 Copyright © 2020 MAT Engine Technologies, LLC
4
3
1
2
Fig. 1