Publicidad
Idiomas disponibles
Idiomas disponibles
Adjustments
Cutting Height - Dual Lever
There is a cutting height adjustment lever located above the front and rear right
wheel.
1.
Pull the height adjustment lever outward towards wheel (unit will tend to
fall when lever is moved outward). See Figure 9.
2.
Move lever to desired position for a change in cutting height. See Figure 9.
3.
Release lever towards deck.
IMPORTANT: All wheels must be placed in the same position. For rough or uneven
lawns, move each height adjustment lever to a higher position. This will prevent you
from cutting the grass too close to the ground.
2
Lower
1
Higher
3
Handle Pitch (If Equipped)
For convenience of operation, you may adjust the pitch of the handle as follows. See
Figure 10:
1.
Place the release levers in the unlocked positions.
2.
Move the upper handle to align the position indicator with the most
comfortable of the three handle positions.
3.
Place the release levers in the locked positions .
a
Position Indicator
c
Handle Positions
2
Higher
Lower
1
3
Figure 9
b
Figure 10
ASSEMBLY
Drive Control (If Equipped)
The adjustment wheel is located in the drive control handle housing and is used
to tighten or loosen the drive belt. You will need to adjust the drive control if the
mower does not propel itself with the drive control engaged or if the mower's
wheels hesitate with the drive control engaged. If either of these conditions occur,
rotate adjustment wheel clockwise to tighten cable or counterclockwise to loosen
the cable. See Figure 11.
10
Loosen
Tighten
Figure 11
Publicidad
