Glacier bay 67624-6001 Guía De Uso Y Cuidado página 6

Installation (continued)
5
Preparing the pop-up assembly
□
Remove the stopper (J) and ange (K).
□
Screw the nut (M) all the way down, and push
the gasket (L) down.
L
M
J
K
6
Installing the pop-up body and
pop-up flange
□
Apply silicone to the underside of the ange (K).
□
Insert the pop-up body (N) into the sink. Screw
the ange (K) onto the pop-up body (N). The
pivot hole (1) must face the back of the sink.
□
Use the groove joint pliers to tighten the nut (M),
but do not over tighten. Do not turn the pop-up
body (N) while tightening the nut (M) or the
sealant may not seal properly. Clean away any
excess putty.
□
Open the easy install rotating clip (O).
M
6
K
N
1
Open
O