Uline DEWALT H-8903 Manual Del Usuario página 4

1. Pull lid latches in an outward motion, remove power
head and some accessories that may have been
shipped in the tank.
2. Attach heavy-duty rubberized casters.
3. Before replacing power head, refer to these
instructions to ensure the proper filters are installed
for the cleaning operation.
4. Replace power head, and apply pressure with
thumb to each latch until it snaps tightly in place.
Ensure all lid latches are clamped securely.
5. Insert air hose end into inlet of tank.
6. Attach extension wands to accessory end of hose.
Apply slight pressure until fitting is tight.
7. Attach one of cleaning accessories (depending
on the cleaning requirements) on extension wands.
Twist slightly to tighten the connection.
8. Plug the cord into wall outlet. Unit is ready for use.
CASTER ASSEMBLY
1. Invert tank.
2. Align caster with indented caster grooves in tank.
3. Firmly push casters down into position. Secure each
with one provided screw. (See Figure 1)
Figure 1
ACCESSORY BAG HOLDER ASSEMBLY
1. Turn tank right side up.
2. Attach two accessory bag
holders by aligning them
with grooved sections.
3. Secure each with two
self-tapping screws.
(See Figure 2)
PAGE 4 OF 21
OPERATION
Figure 2 Self-Tapping
Screws
4. Place accessory bag holder into hole of bracket.
(See Figure 3)
Figure 3
WARNING: To reduce risk of fire or explosion, do
not operate vacuum in areas with flammable
gases, vapors or explosive dust in the air.
Flammable gases or vapors include but
are not limited to: lighter fluid, solvent-type
cleaners, oil-based paints, gasoline, alcohol or
aerosol sprays. Explosive dusts include but are
not limited to: coal, magnesium, aluminum,
grain or gun powder. Do not vacuum explosive
dust, flammable or combustible liquids or hot
ashes. Do not use vacuum as a sprayer for any
flammable or combustible liquid. To reduce
risk of health hazards from vapors or dusts, do
not vacuum toxic materials.
WARNING: Operation of any utility vacuum
can result in foreign objects being blown into
the eyes, which can result in severe eye injury.
Always wear safety goggles complying with
ANSI Z87.1 (or in Canada, CSA Z94.3) before
starting operation.
CAUTION: To reduce risk of hearing loss,
wear ear protectors when using vacuum for
extended hours or when using it in a noisy area.
Unit is ready for dry vacuuming or blowing.
After the plug the power cord into the wall
receptacle, turn the unit "ON" by pushing the
switch position. (See Figure 4)
Figure 4
ON OFF
ON
0421 IH-8903
OFF