Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Эта инструкция скачана с сайта www.remington-shop.ru
INSTRUCTIONS FOR USE
Before use make sure hair is clean, dry and tangle free.
Clip-up hair ready for styling.
Plug in the unit, press and hold the on-off switch for two seconds to switch on. Press again
for two seconds to switch off. Unplug from the mains when not in use.
Rotate the variable wheel to decrease or increase the temperature until the desired
temperature is reached.
Take approximately one inch sections of hair and place firmly under the tong clip.
Turn the tong handle to roll hair onto heated barrel. Allow approximately 10 seconds for
curl to form.
For tighter curls use smaller sections, for looser curls and waves use larger sections.
Unwind the tong and depress the clip to release the curl.
Allow hair to cool before styling.
IMPORTANT INSTRUCTIONS
Due to the extreme heat capabilities of this styler, extra care should be taken when using.
While heating, during use and cooling, place on flat, smooth, heat-resistant surface. Only
hold unit at the end of the handle.
This is a high performance product, avoid frequent use to prevent damage to hair.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.
CLEANING AND MAINTENANCE
Ensure the unit is unplugged and cool. Wipe clean any build up of styling products with a damp
cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.
SAFETY CAUTIONS
WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION
OF A RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL
OPERATING CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN
ELECTRICIAN FOR ADVICE.
2
Publicidad
