Ryobi GD200A Manual Del Operador página 17

 Pull the front pulley and belt to the top of the rail assembly.
 Turn the tension nut on the pulley rod counterclockwise
to loosen. Remove the tension nut and spring from the
pulley rod.
 Move the front pulley back into the rail assembly.
 Insert the edge of the front brace into the front rail. Slide
together until brace clicks in place. If you cannot get the
Sleeve
Front
Rail
Pulley
Spring
Rod
Tension
Nut
Front
Brace
ASSEMBLY
Intermediate
Rail
Fig. 13
Sleeve
Fig. 14
Front
Front
Rail
Pulley
Fig. 15
Front
Front
Rail
Pulley
Fig. 16
brace to fit by hand, try gently tapping it with a rubber
mallet until it is snug.
 Pull the front pulley forward and slide the rod through the
hole in the brace.
 Install spring and tension nut onto pulley rod.
 Move the inner and outer trolley to the middle of the rail
assembly.
Pulley
Spring
Tension
Nut
Tension
Nut
Front
Brace
17 - English
Front
Brace
Rod
Spring
Front
Rail
Fig. 17
Fig. 18