Publicidad
Idiomas disponibles
Idiomas disponibles
Please Note:
If the appliance is switched off you must wait at least 5 minutes before
restarting the appliance or re-inserting the plug into the wall outlet.This is to allow the
protection device in the compressor to reset.
If the compressor fails to start correctly remove the plug and wait for 5 minutes before you
try again then the compressor should restart normally.
The storage temperature may be affected by:
– The room temperature
– How often the door is opened
– How much food is stored
– Position of the appliance
When you set the correct temperature, all these factors mentioned above shall be taken
into account.
THE CHILLER COMPARTMENT
This compartment is designed for production of ice cubes and short-term storage(3-4 days
at most) of some commercially frozen foods.
The temperature in this compartment does not get cold enough to freeze food safely for long
periods of time and works best when the food is already frozen.
By design, this chiller compartment is not a true freezer, and may not keep ice cream frozen,
or freeze items.
A colder setting may be used for these items, but other items in the refrigerator may also
be affected.
The chiller door is susceptible to breaking due to excessive ice build up.This part is not covered
under your warranty. Be sure to defrost when the ice reaches 6cm thick even if the defrosting
is automatic.
40
REVERSE DOOR
Tools Required: Phillips style screwdriver / Flat blated screwdriver
/ Hexagonal spanner
•
If you want to have the door swing reversed,we recommend that you contact a
qualified technician. You should only try to reverse the door yourself if you believe
that you are qualified to do so.
•
Ensure the unit is unplugged and empty.
•
Adjust the two levelling feet to their highest position.
•
To take the door of it is necessary to tilt the unit backwards. You should rest the
unit on something solid so that it will not slip during the door reversing process.
•
All parts removed must be saved to do the reinstallation of the door.
•
Do not lay the unit fat as this may damage the coolant system.
•
We recommend that 2 people handle the unit during assembly.
Follow the following stages to reverse the door from its initial position.
1.Remove the right top hinge cove r and unscrew the top hinge.
2. Remove the door from bottom.
41
Publicidad
