MTX Audio TERMINATOR TR8PT Manual De Instrucciones página 2

Introduction
Thank you for purchasing an MTX Audio Hi-Performance powered tube. Proper installation matched with MTX
speakers and amplifiers provide superior sound and performance for endless hours of waking the neighbors,
slammin' your friends or flat out stomping wanna-be players. Congrats and enjoy the ultimate audio experience
with MTX !
Features
• Powered vented enclosure
• Subwoofer : 20cm (8")
• Amplifier Max Power : 360W
• Amplifier RMS Power : 120W
• High and low level inputs
• Dimensions : 25x25x54cm
• Optional EBC (External Bass Control) remote
Control Panel on the Amplifier
HLI EBC
L R
+ +
- -
Speaker level inputs (HLI) : This input will allow the amplifier to operate from source units with speaker-level
outputs. Output speaker leads from the source unit should be tied directly to the wire harness provided with
the amplifier.
Note : When speaker level inputs are used, a remote turn on wire must used to switch the amplifier on and off.
Remote control port (EBC) : use this port to connect the optional MTX EBC. It alows you to control the output
level siting at the front of the car.
RCA Inputs (Input) : These RCA inputs are used with source units that have RCA or Line level outputs. (Source
units need a minimum level of 100mV output for proper operation of the amplifier).
MTX recommends only high quality twisted pair cables (such as StreetWires) to decrease the possibility of radi-
ated noise entering the system.
Gain Control (Gain) : The gain control matches the input sensitivity of the amplifier to the source unit being used.
The operating range varies from 100mv to 6V.
Adjusting the gain
1. Turn the gain control on the amplifier all the way down (counter clockwise).
2. Turn up the volume control on the source unit to approximately 3⁄4 of maximum.
3. Adjust the gain control on the amplifier until audible distortion occurs.
4. Adjust the gain control down until audible distortion disappears.
5. The amplifier is now calibrated to the output of the source unit.
Low Pass X-Over Frequency Control (LP) : Used to select the desired low-pass (LP) x-over frequency. The fre-
quency is adjustable from 50Hz to 200Hz..
Protection LED (Prot) : When the amps is in thermal protection, the LED turns to red.
Input
Gain LP
6V - 0,1V 50Hz - 200Hz
www.mtx.com - www.mtx.eu.com
Prot.
ON.
+12V GND
Rem
TR8PT
20cm (8") 120W
Powered Tube
30A