Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
INSTALLING THE STRAINER
NOTE:
If you are installing a garbage disposer (not supplied), do not install the strainer.
- Position the drain (3) and the gasket (4) into the drain opening of the
sink . Silicone or plumbing putty may be used instead of the gasket (4) .
- Remove any major surface irregularities from around the bottom of the
drain opening .
- Fill both grooves of the bottom seal (5) with silicone sealant (not
supplied) .
- Push the bottom seal (5) with the grooves against the bottom of the
sink such that it is evenly seated .
- Put a small bead of silicone around the flange of the lower strainer
body (6) .
- Press the lower strainer (6) body into the bottom seal (5) and secure
components with the strainer screw (2) .
- Tighten the strainer screw (2) until all gaps are eliminated and all the
components are tightly seated flat against each other.
- Wipe off excess sealant and allow it to cure as suggested by the
sealant manufacturer before connecting your plumbing .
- Insert the plastic flange (7) into the tail pipe (8), and secure them to
the lower strainer body (6) using the connecting nut (9) as indicated by
the manufacturer .
Strainer basket (1)
Strainer screw (2)
Bottom seal (5)
Lower strainer body (6)
Plastic flange (7)
Tail pipe (8)
(not supplied)
Connecting nut (9)
Bottom seal (5)
Lower strainer body (6)
9
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
Drain (3)
Gasket (4)
Sink (A)
Sink (A)
Gasket (4) Drain (3)
Silicone
Silicone
DRAIN INSTALLATION DETAIL
CONGLOMKB .COM
Silicone
Silicone
Publicidad
