MTX Audio THUNDER TH800D Manual De Instrucciones página 4

Connectors panel :
RCA Inputs - These RCA inputs are used with source units that have RCA or
Line level outputs. (Source units need a minimum level of 100mV output for
proper operation of the amplifier).
MTX recommends only high quality twisted pair cables (such as StreetWires)
to decrease the possibility of radiated noise entering the system.
High Level Inputs :
MTX amplifiers allow high level inputs through RCA type input connections.
Simply connect the head unit speaker leads to the provided adapters.
Speaker Terminals - Connect subwoofer(s) to these terminals. If using two sub-
woofers or a dual voice coil subwoofer, respect the phase.
Attention : The two (+) connectors are wired parallel internally. Same for the
two (-) connectors.
Thermal Protection - This LED illuminates red when the amp reaches 100°C. The LED also turns red when the
power supply goes below 9V or over 16.2V.
Short Circuit Protection - This LED will flash yellow when the speaker outputs will short circuit. Without signal,
this LED can remain yellow when the speaker outputs are short circuited.
Fuses - When fuses blow, replace them with the same value. Never use a higher rated fuse !
(+12) Power Terminal - This is the main power input for the amplifier and must be connected directly to the posi-
tive terminal of the vehicles battery for proper operation. Use caution when installing (+12) power cable in the
vehicle. Avoid running this cable parallel with RCA cables, antennas, or other sensitive equipment due to massive
currents that can induce noise into the audio system. It is also very important to have a tight, secure connection
for maximum performance. MTX recommends using 50mm
Remote Terminal – The amplifier can be turned on by applying 12 volts to this terminal. Typically this voltage is
supplied by a wire from the source unit marked "remote" or "power antenna".
Ground Terminal – A proper ground is required for your amplifier to operate at peak performance. A short ground
cable the same diameter as the power cable should be used to attach the ground terminal directly to the chassis
of the vehicle. Always remove paint, dirt or debris to expose bare metal where the ground will be attached.
EBC Port (External Bass Control) - The Remote Subwoofer Level Control (EBC) plugs directly into this port, while
the EBC itself can be placed anywhere in the vehicle for on demand bass adjustments. EBC is included.
www.mtx.com - www.mtx.eu.com
Adaptors
included
2 power wire with the MTX TH800D amplifier.
High level inputs
through RCA
To Head
Unit
Speakers