Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the appliance
1. Remove the pan supports, the burner lid and flame spreader and carefully
turn the appliance upside down and place it on a cushioned mat. Take
care that the Ignition devices and flame supervision devices are not
damaged in this operation.
2. Apply the sponge provided around the edge of the appliance.
3. Do not leave a gap in the sealing agent or overlap the thickness.
(A) SEALING STRIP
(C) SCREW
1. Place the bracket (B) over the holes that
2. Carefully turn the hob back over and then
3. On the underneath of the hob, adjust the
(B) BRACKET
Do not use a silicon sealant to seal the
appliance against the aperture.
This will make it difficult to remove the
appliance from the aperture in future,
particularly if it needs to be serviced.
match the size of the screws.There are one
set of screw holes in each corner of the hob
(H).
Slightly tighten a screw (C) through the
bracket (B) so that the bracket is attached to
the hob, but so that you can still adjust the
position.
gently lower it into the aperture hole that you
have cut out.
brackets into a position that is suitable for
your worktop. Then fully tighten the screws
(C) to secure the hob into position.
17
V.3
Publicidad
