Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
• Save all instructions
A
Before Operating
Before operating or using the log splitter, review the instructions below and all safety information. Failure
to follow these instructions may result in property damage or injury to the operator or bystanders.
WARNING
•
Use the log splitter only for its intended use of splitting wood.
•
When changing the splitter from vertical to horizontal operation, do not let the beam suddenly drop. Keep
hands and fingers clear of pinch or crush points at all times.
•
When operating in the vertical position, make sure the beam lock pin engages the beam to prevent
inadvertent movement.
•
Use the log splitter to split wood logs length wise with the grain.
•
Never modify, alter or change the log splitter in any way.
•
Never attach a rope, cable or other device to the control lever on the log splitter.
•
Operate the log splitter only in daylight with good light and visibility.
•
Do not leave the log splitter unattended while the engine is running.
•
Do not change the splitting position with the engine running. Contact with the muffler can cause
serious burns.
•
Never operate or let anyone else operate, the log splitter while under the influence of alcohol, drugs, or
medication.
B
Pre-Start Check List
1. Make sure all safety guards are in place and all nuts and bolts are secure.
2. Always wear safety gear, eye protection, gloves and work boots when operating the log splitter.
3. Make sure the machine is on a dry and flat surface. Block the wheels to prevent movement. Do not operate
on slopes greater than 5 degrees. (See Slope Guide)
4. Lock the beam in the horizontal or vertical position.
5. Check oil level in engine crankcase and the hydraulic tank. See your Engine Owner's manual for
procedure and specifications.
6. Visually inspect all hoses and attachments for leakage and security.
7. Inspect air cleaner for cleanliness. See your Engine Owner's manual for procedure.
8. Check the fuel supply. Fill the fuel tank no closer than 1/2" (12.7 mm) from top of tank to provide space for
expansion. See your Engine Owner's manual for fuel recommendations.
9. Be sure spark plug wire is attached and spark plug is tightened securely.
10. Look for signs of damage to machine and engine.
11. Remove excessive debris from engine guards and muffler area.
12. The log splitter must have at least seven feet of clearance from combustible material. It needs to be on a
dry and level surface with good footing. Do not work on mud, ice, brush or snow. When using the log splitter
the work zone must be maintained at all times.
C
Towing Precautions
WARNING
Serious injury or death can occur if towing safety rules are not followed.
•
Before towing the log splitter, check tires for excessive wear, cuts or damage. Check for proper tire
inflation. Add air as required. Do not over inflate tires. Serious injury can result if tires explode.
•
Verify the correct ball size of 2 inches is on the towing vehicle.
•
Refer to the vehicle owner's manual for proper safety and towing instructions.
•
Always use safety chains, secure and lock the log splitter to the vehicle hitch before moving. Drive safely.
Be aware of the added length of the log splitter.
•
Never exceed the maximum travel speed of 45 mph.
•
Never ride or transport cargo on the log splitter.
•
Turn off the vehicle before leaving the log splitter unattended. Block the log splitter wheels to prevent
unintended movement.
Questions? Call Toll Free at 1-800-737-2112
ENG - 12
Copyright © 2017 MAT Engine Technologies, LLC
Publicidad
