Publicidad
Idiomas disponibles
Idiomas disponibles
6. Wall Mounting the Enclosure
Warning: Do not attempt to mount the enclosure to the wall with equipment mounted in the
enclosure.
There are 6 keyhole cutouts on the back door of the enclosure. Each keyhole can accommodate an M10 or 3/8" bolt. The holes are 16" apart
horizontally and 29" apart vertically, to match typical stud spacing, as shown in diagram.
Note: Do not lift the enclosure into mounting position with the doors installed. Always remove doors prior to lifting to reduce the enclosure's weight.
Using a level, measure to position your mounting areas precisely. Use appropriate fasteners (not included) to secure the enclosure to the wall.
Warning: The area you plan to mount the enclosure to must be able to withstand the weight of the enclosure and all mounted
equipment. For the weight of the enclosure and its capacity, refer to the Specifications section on page 7.
406.4 mm
12U: 18.5 in.
469.8 mm
18U: 29 in.
736.6 mm
32 in.
812.8 mm
16 in.
16 in.
406.4 mm
6
Publicidad
