MBM BRG98A/912T Manual De Instalación página 48

- The pilot light can be seen through the
hole on the panel.
- Then turn it to the burner ignition posi-
tion (Figure 10E). Check to make sure
the pilot light remains lit (Fig.11).
- When the pilot light has been lit, turn
the knob to the desired position (Fig.
10A). Lighting of the red indicator me-
ans that the heating phase is in pro-
gress (Fig. 10C).
- Turn the knob to "Zero" (Fig. 10G) to
switch off the burner.
When the work cycle is over, in or-
der to speed up a new production
cycle, you may turn the burner off
while leaving the pilot light on.
- Turn the valve to "0" (Fig. 10F) and the
knob (Fig. 10A) to "0" to shut down the
equipment.
UNLOADING THE PRODUCT - see
SECT. IMAGES - REF. p).
Move the cooking compartment
only after having positioned an
appropriate recipient below the
product outlet.
When unloading the product, fill
the collection recipient halfway
for safe handling.
When cooking is over, position and
block a recipient (with appropriate ma-
terial and capacity) underneath the co-
oking compartment (Fig. 10 A/B).
Unloading product from cooking com-
partment: 1. Lift the lid of the cooking
compartment all the way (Fig.11);
2. The container suitable to receive the
product (Fig. 10A/B) must not obstruct
flywheel rotation (Fig.12);
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
INSTRUCTIONS FOR USE
3. Begin turning the flywheel stepping
to the side of the appliance (Fig.12). As
the cooking compartment moves it will
allow the product to slide towards the
container;
4. Act on the flywheel to increase or
decrease inclination of the cooking
compartment and therefore unloading
speed;
5. Keep an eye on the filling of the re-
cipient.
The material inside the collection
container must not overflow.
When the cooking compartment has
been emptied, put the cooked product
in a place prepared beforehand.
If necessary, repeat the aforementio-
ned operations until the cooking com-
partment is empty.
After the product has been unloaded,
load it once again (see "Loading Cooking
Compartment") or else perform the ope-
rations described in "Deactivation".
DEACTIVATION - see SECT. IMA-
GES - REF. p).
At the end of the work cycle, turn
the knobs on the appliance to
"Zero".
The appliance must be cleaned
regularly and every incrustation
or food deposit removed. See
chapter "Maintenance".
If present, the indicator lights must
be off at the end of the work cycle.
1. Check the cleanliness and hygiene
of the appliance. See "Maintenance".
2. Close the network locks upstream
the appliance (Gas - Water - Electric).
- 20 -