Escalade Sports STIGA T8731 Manual Del Propietário página 5

5. Lay Table Top (#1) painted side down, on a smooth, flat
surface. Use the shipping container to protect the painted
surface of table top.
6. Align the "U" Support (#21) on Table Top (#1) as shown in
Figure 5.
7. Align all four holes in each U-Clip (#22) with the four pilot
holes in table top. Be sure that Slot in the Three U-Clips (#22)
all face the same direction toward the end of the table with no
stripe and no pilot holes. Secure U-Clips (#22) with Screws
(#5) as shown in Figure 5 & Detail A.
Note: All four holes in the U-Clip (#22) must align with
four pilot holes in table top. See Detail A.
21
Detail A
8. Rotate U-support (#21) that is on bottom of Table Top until
you see the screw holes in the slots of U-clips (#22). If
necessary Slide U-support (#21) side to side and back and
forth to see holes. See Figure 5 & Detail B.
9. Insert Screw (#35) through slot in U-clip (#22) and into U-
support (#21). See Figure 5 & Detail B. Thread screw all the
way into U-support until it touches the back of the tube. There
should be about 3/8" of screw (#35) left sticking out. Repeat
for second Screw (#35) and U Clip (#22).
Note: To aid in assembly you can use a cordless drill and
Phillips bit for Step 9 only. Wear safety glasses.
1
5
22
CAUTION:
WHEN ASSEMBLING TABLE, IT IS EXTREMELY IMPORTANT THAT THE U-
CLIPS (#22) BE TURNED AS SHOWN HERE. IF U-CLIPS ARE TURNED
INCORRECTLY, YOU WILL DO IRREPARABLE DAMAGE TO YOUR TABLE
WHEN YOU ATTEMPT TO OPEN IT TO THE PLAYING POSITION.
Note: End with no stripe
and no pilot holes.
5
35
21
22
Detail B
Figure 5