Publicidad
Idiomas disponibles
Idiomas disponibles
SB-100SX TOOL SPECIFICATIONS
All screws and nuts are metric.
MODEL
TOOL ACTUATION
SB-100SX
Sequential Trip
FASTENER SPECIFICATIONS:
TOOL MODEL
STAPLE SERIES
SB-100SX
SX5035
TOOL AIR FITTING:
This tool uses a free-flow connector plug, 1/4 N.P.T. The inside diameter should be .200" (5mm) or larger. The
fitting must be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i.g. (4.9 to 7.0 kg/cm2). Select the operating pressure within this range for best fastener
performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
The SB-100SX requires 2.2 cubic feet (.06 cubic meters) of free air to operate at the rate of 100 staples per
minute, at 80 p.s.i. (5.6 kg/cm2). Take the actual rate at which the tool will be run to determine the amount of
air required. For instance, if your fastener usage averages 50 nails per minute, you need 50% of the tool's c.f.m.
which is required to operate the tool at 100 staples per minute.
OPERATION
SEQUENTIAL TRIP:
The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. This makes
accurate fastener placement easier, for instance on framing, toe nailing and crating applications. The Sequential
Trip allows exact fastener location without the possibility of driving a second fastener on recoil, as described under
"Contact Trip". The Sequential Trip Tool has a positive safety advantage because it will not accidentally drive a
fastener if the tool is contacted against the work – or anything else – while the operator is holding the trigger pulled.
MODEL IDENTIFICATION:
Refer to Operation Instructions on page 7 before proceeding to use this tool.
SEQUENTIAL TRIP
Identified by
GRAY TRIGGER
LENGTH
HEIGHT
9-1/2" (241.3mm)
8-3/4" (222.2mm)
GAUGE
FASTENER RANGE
18
1/2" - 1" (12mm-25mm)
-4-
WIDTH
WEIGHT
2" (50.8mm)
2.65 lbs. (1.2 Kg)
Publicidad
