BMC E-20A-H-O Manual Del Usuario página 19

(2) Point the four holes of the Base Plate towards the four reference points on the back of the
main device to properly stick the plate to the device, as shown in Fig. 11-11.
Base Plate
(3) Point the two Buckles at the back of the SpO
base plate, and push until the two units click into place. Insert the SpO
Communications Port of the main device, as shown in Fig. 11-12.
11.7.2 Removing the SpO
First disconnect the SpO
2
at the top of the SpO Kit adapter, and at the same time, pull the adapter and base plate apart
2
in opposite horizontal directions, as shown in Fig. 11-13.
Hook
The SpO Kit is intended to be used for continuous, non-invasive functional arterial oxygen
2
saturation (SpO ) and pulse rate monitoring for adults weighting greater than 40 kg.
2
E-20A-H-O / E-20AJ-H-O User Manual V2.3
Fig. 11-10
Fig. 11-11
Buckle Communications Port
Fig. 11-12
Kit from the Main Device
2
Kit connector from the Communications Port; then press the Hook
Fig. 11-13
15 / 36
Base Plate
Adhesive-backed Paper
Kit adapter towards the two buckles of the
2
Kit connector into the
2