Publicidad
Idiomas disponibles
Idiomas disponibles
1. Attach Caster Wheels (#9 & #10) to Caster Beam Assembly
Slide a Caster Wheel with Lock (#10) through Caster Beam
Assembly (#7) and secure it with a Push Nut (#11) as shown in
Figure 1. Gently tap the Push Nut (#11) with a hammer to secure it
in place. On the other end of the Caster Beam attach a Caster Wheel
without Lock (#9). Make sure you have one caster wheel with lock
and a caster wheel without lock for each Caster Beam Assembly.
Repeat this step to attach the Casters to the second Caster Beam
Assembly.
2. Attach Wood Bottom Board
(#15) to Caster Beam
Assemblies (#7) as shown in
Figure 1. Turn Caster
Beams as shown and attach
board with four Carriage
Bolts (#31) and four Wing
Nuts (#32). Tighten Thumb
Screws securely.
3. Attach Strut Tubes (#17) and Linkages (#16) to Caster Beam Assemblies (#7) as shown in Figure 2.
a) Loosen Bolts (#13) and Nuts (#28) so that Strut Tube (#17) can fit between Support Plate (#43) and Caster
Beam (#7) as shown in the Top View and Figure 2.
b) Slide one Hex Bolt (#27) through Caster Beam (#7), one Plastic Washer (#39), Strut Tube (#17), Plastic Washer
(#39), Support Plate (#43) Spacer (#36), Linkage (#16) and Locknut (#28) as shown in Figure 2 Top View.
c) Repeat on other end of Caster Beam (#7) and on second Caster Beam.
d) Tighten Bolts (#13) and Nuts (#28) securely.
e) Tighten Nuts (#28) on Bolts (#27) securely.
16
Figure 2
11
7
10
Caster
with
Lock
Note: Strut tubes must
be turned as shown or
table will not operate
correctly.
17
39
7
27
(#7)
.
READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND
SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2)
ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER!
Note: Support Plate (#43)
must be on inside of Caster
Rail (#7) as shown.
31
Caster
9
without
Lock
32
17
28
36
3
43
15
Figure 1
Top View
28
36
43
39
7
13
27
16
31
7
32
10
Caster
with
Lock
16
17
12
13
Publicidad
