POWER LIGHT:
This heater is equipped with a power indicator light. This light will illuminate when control is turned to Fan Low or High
position.
OVERHEAT SAFETY FEATURE:
This heater is equipped with an automatic overheat protection device. If the heater grill is obstructed, or if the heater
gets too hot for any reason, the automatic overheat device will turn the heater off. To reset the heater, simply turn off
the power and unplug the heater remove any obstructions, leave unplugged for 10 minutes until it cools completely.
Then plug the heater back into outlet and turn unit on.
TIP-OVER SAFETY FEATURE
This heater is equipped with a safety tip-over device. Once the heater is tipped over, an external switch located on the
bottom of the heater will automatically shut the heater off. Once the heater is restored to an upright position, the
heater will reset.
INSTRUCTIONS FOR POWER
WARNING: Before servicing this heater be sure to unplug heater from wall outlet. Do
not only turn off heater from the main "ON/OFF" switch, be sure to unplug this heater.
Note: The power cord has a polarized plug (with one blade wider than the other) that will only fit in a polarized outlet
one way. If it does not insert easily try reversing the plug. If it still does not fit contact your electrician to replace your
outlet. DO NOT defeat the safety purpose of the polarized plug.
ELECTRICAL CONNECTION
A 15 AMP, 120 Volt, 60Hz circuit with a
properly grounded outlet is required.
Preferably, the heater will be on a dedicated
circuit. Other appliances on the same circuit
may cause the circuit breaker to trip or the
fuse to blow when the heater is in operation.
WARNING: Electrical
outlet wiring must comply with
local building codes and all
other applicable regulations to
reduce the risk of fire, electrical
shock and injury.
WARNING: Do not use this
appliance if any part of it has
been under water. Immediately
call a qualified service technician
to inspect the appliance and
replace any part of the electrical
system if necessary.
~ 3 ~