Charging The Battery; Power Settings - Shark ROCKET IX140 Serie Manual Del Propietário

CHARGING THE BATTERY

LI-ION CHARGER
Plug the Li-Ion Charger into a wall outlet.
NOTE: MultiFLEX wand is not included with all configurations. See enclosed Quick Start Guide for your unit's configuration.
NOTE: Battery can only be charged in the vacuum.
s h a r kc l e a n . c o m
OPTION 1 – IN HANDHELD VACUUM
Remove the handheld vacuum from the wand by
pressing the Wand Release button and pulling
up. Plug the charger into the charging port on the
handheld vacuum.
OPTION 2 – MULTIFLEX® STORAGE MODE
To put the vacuum in storage mode, press the
MultiFLEX Wand Unlock Latch while folding the
handheld vacuum forward until the wand clicks and
locks. Plug the charger into the charging port on the
handheld vacuum.

POWER SETTINGS

OFF
Slide switch to the top to turn off power.
To begin vacuuming in Standard Mode, slide switch
to the desired setting.
CARPET SETTING
Carpet
Use this setting to pick up debris below the surface
of your carpets.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please use setting II, Carpet. The Carpet setting
should also be used when cleaning stuck-on dust and debris.
BARE FLOOR SETTING
Bare Floor/Small Area Rugs
Use this setting to clean bare floors and small
area rugs.
BOOST MODE
For an added boost in power, pull the Trigger on the
handheld vacuum. Release it to return to standard
power.
s h a r kc l e a n . c o m