Muskoka MFB42WSC Manual De Uso Y Cuidado página 5

OPERATING INSTRUCTIONS
The firebox main power "on/off" switch (see Fig. 4) must be switched "on" before any of the control
functions, (on the firebox and/or remote control) will operate. NOTE: The main switch does not have to
be turned off when the firebox is not being used for brief time periods. If however, you are not planning
to use your firebox for extended time periods or going away on vacation, we recommend the main power
"on/off" be switched off.
This firebox insert features conveniently separate controls for the flame effect and heat control.
This feature allows you to operate the unit in 2 different ways;
• As a full featured fireplace insert with both flame effect and heater operating simultaneously.
• As a visual effect with flame effect only. (i.e. no heating cycle)
This firebox insert is not designed to operate in "heat" only mode without a flame effect.
NOTE:
All of the firebox control functions can be accessed in 2 ways:
Fig. 3
Fig. 4
4 3
1. Using the remote control:
1. Main Power Button:
the firebox, the flame effect (only) will turn on. To turn
the firebox "off" press the "main power button" again.
1
2. Flame Effect:
desired effect. You can go up 4 steps after flame shuts
2
off (no heat)
3. Heat:
4
heat setting; twice for "high" heat setting; three times
for "medium" heat setting and a fourth time for "low"
setting" (
3
heat cycle is operational) Pressing the button a "fifth"
time turns the heater off.
4. Accent Light button:
refractory and can act as a night light.
2. Using the manual controls located on
the firebox behind the upper front
access panel.
2 1
1. Main Power Button:
on the firebox, the flame effect (only) will turn on.
To turn the firebox "off" press the "main power
button" again.
2. Flame Effect:
desired effect. (no heat)
3. Heat:
4. Accent Light Button:
refractory and can act as a night light.
4
Press the "main power button" on
Press the flame button to achieve the
"Press the heat button once for "ultra-high"
the flame effect is always on when the
NOTE:
This light illuminates the brick
Press the "main power button"
Press the flame button to achieve the
(See details above under Remote Control)
This light illuminates the brick