PROBLEM
Grill only heats to 93-149°C / 200-300°F.
Grill takes a long time to preheat.
Burner flames are not light blue.
HOW TO ORDER REPLACEMENT PARTS
To make sure you obtain the correct replacement part (s) for
your gas grill, please refer to the parts list on pages 63. The
following information is required to assure getting the correct
part. Please note the shipping cost for the delivery of any
replacement parts will be on yourself.
•
Gas grills model number (see data sticker on grill).
•
Part number of replacement part needed.
•
Description of replacement part needed.
•
Quantity of parts needed.
SOLUTION
Check to see if the fuel hose is bent or kinked.
Make sure the grill area is clear of dust.
Make sure the burner and orifices are clean.
Check for spiders and insects.
The regulator has a safety device that restricts the flow of gas in the event of a
leak. This safety device can be triggered without a gas leak. To reset the
safety device, turn off all burners and close the LP tank valve. Disconnect the
regulator from the LP tank and wait one minute. Reconnect the regulator to the
LP tank and slowly open the LP tank valve until the valve is fully open. Light all
burners and observe the temperature.
Normal preheat 260-316°C / 500-600°F, takes about 10-15 min. Cold weather
and wind may effect your preheat time.
If you are using volcanic rock or briquettes they can increase the preheat time
and maximum temperature.
Too much or not enough air for the flame.
Elevation is the principal cause, however cold weather can affect the mixture.
Burner adjustment may be required.
Grill is in a windy location.
To obtain replacement parts, contact our customer service
hotline, U.S.A: 1- 866-994-6390.
IMPORTANT
Use only factory authorized parts. The use of any part that
is not factory authorized can be dangerous. This will also
void your warranty.
Keep this assembly and operating instruction manual for
convenient referral, and for replacement parts ordering.
13
Ordering Parts