CAT Pumps CT80020 Manual Del Operador página 15

RAISING AND LOWERING THE HANDLE
See Figure 5.
 To raise the handle: pull the handle up until the handle
release knob snaps through the locking hole to secure
the handle in place.
 To lower the handle: pull the handle release knob out then
lower the handle to the position.
ATTACHING THE REAR PANEL
See Figure 6.
 Locate the rear panel, 4 lock nuts, and 4 screws (1.4 in.).
 Using a screwdriver (not provided), secure panel to handle
using the screws and nuts.
ATTACHING THE TRIGGER HANDLE HOLDER
AND STORAGE HOOK
See Figure 7.
 Raise handle as described in the Raising and Lowering
Handle section.
 Locate the trigger handle holder and lock nut.
 Insert the trigger handle holder into the handle.
 Install lock nut; tighten securely.
 Locate the trigger handle storage hook and lock nut.
 Insert the trigger handle storage hook into the pressure
washer frame, as shown.
 Install lock nut; tighten securely.
ATTACHING THE SPRAY WAND STORAGE HOOK
See Figure 8.
 Locate the spray wand storage hook, rubber grommet,
and lock nut.
 Slide the spray wand storage hook through the hole in
the rubber grommet.
 Insert the spray wand storage hook into the pressure
washer frame, as shown.
 Install lock nut; tighten securely.
ASSEMBLY
ASSEMBLING THE TRIGGER HANDLE
See Figure 9.
 Place the threaded end of the spray wand in the connector
on the end of the trigger handle.
 Turn the connector clockwise until it stops. This secures
the spray wand in place.
 When not in use, remove the spray wand from the trigger
handle by turning the connector counterclockwise. Store
the unassembled spray wand in the spray wand storage
area.
ATTACHING THE AUXILIARY HANDLE
See Figure 9.
 Place the threaded stud on the end of the auxiliary handle
into the hole in the trigger handle as shown. Turn clock-
wise to tighten.
NOTE: You can install the handle on either the left or right
side of the spray wand, depending on operator prefer-
ence. The handle must always be used to prevent loss
of control and possible serious injury.
 To switch sides, remove the auxiliary handle and place
on the opposite side. Tighten securely before use.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 10.
 Pull back and hold the collar on the high pressure hose.
Insert the inlet coupler on the trigger handle into the collar.
 Release the collar and push until it locks into place. Pull
on the hose to be certain it is properly secured.
ATTACHING INJECTION HOSE
See Figure 11.
Before detergent can be used with this machine, the injection
hose must be attached.
 Push the open end of the clear injection hose securely
over the fitting on the pressure washer.
NOTE: Keep injection hose away from hot surfaces.
 Place the filtered end of the injection hose in the bottle
of detergent (not provided).
Page 9 — English