Torin BIG RED T83000F Manual Del Propietário página 6

ASSEMBLY
1. Familiarize yourself with the jack.
Lifting Arm
Oil Fill Plug
2. Prior to assembly, carefully remove the retaining
clip attached to the handle socket. CAUTION:
The socket will tend to spring upward when the
clip is removed. To prevent possible injury, place
one hand on the top of handle socket to control
the upward motion of the handle socket retaining
clip, and then carefully remove the retaining clip.
After removed slowly allow handle socket to rise
back into resting position.
WARNING!
Once retaining clip is removed,
SLOWLY allow handle socket to rise
back into resting position. Use
CAUTION when removing retaining
clip, handle socket will spring forward
rapidly.
Saddle
Front Wheel
Handle
Pump Plunger
Rear Swivel
Casters
Clip
3. Refer to picture 2 when performing this step.
Press Quick Disconnect on handle piece 2, this
will allow slide handle pieces 1 and 2 connect,
align the holes on both sections to allow quick
disconnect to trigger. Quick disconnect will
automatically pop out when hole position is
correct.
Handle
PC. 1
4. Unfasten the screw located in the Handle Socket
to insert the assembled handle.
5. Line up the square whole located at the bottom of
the handle over the square bolt inside the Handle
Socket. (SEE IMAGE STEP 6)
6. Secure the handle in place by tightening the
screw in the Handle Socket Without any vehicle
on the jack. Cycle the lift up and down several
times to insure the hydraulic system is operating
properly. (Perform to the Air Purge Procedure
before first use.)
WARNING: Do not lift or carry jack by handle.
Handle could dislodge and jack may fall,
resulting in possible injury or property damage.
6
Handle
PC. 2
Quick
Disconnect
Handle Socket
Screw