Black and Decker HLVA315J Manual De Instrucciones página 7

Fig. H
• The top of the bowl is open when the bowl is removed
so that dust can be easily emptied without touching
the filter.
• Figure i - Empty the dust from the bowl
• To replace the dust bowl, place it back onto the handle
until it "clicks" firmly into position.
For a more thorough cleaning, remove bowl as
described below.
Fig. I
For a More Thorough Cleaning (Fig. J, K1, K2)
nOTE: Either a bag filter
with these vacuums.
Figure J - Press the dust bowl release button
•
handle and remove the dust bowl.
• Remove filter from within the bowl.
Fig. J
2
4 .
4
7 or a pleated filter 8 will work
• Shake or lightly brush any loose dust off filter.
nOTE: The brush on the nozzle can be used to remove
•
dirt on the filter.
Bag Filter and Pre-Filter (Fig. K1, K2)
The bag filter and pre-filter can be separated to allow for
better cleaning.
Twist the bag filter to separate it from the pre-filter.
• The dust bowl
water. Allow to dry before placing back into the vac.
Fig. K2
• If using a bag filter, twist the two pieces back together
after they have fully dried.
• Place filter back into the bowl pressing firmly to ensure
2 on the
a secure fit.
• To replace dust bowl, place it back onto the handle until it
"clicks" firmly into position.
iMPORTAnT: Maximum dust collection will only be
obtained with a clean filter and an empty dust bowl. If dust
begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
7
• Wash the filters regularly using warm, soapy water and
ensure that it is completely dry before using again. The
cleaner the filter is, the better the product will perform.
• It is very important that the filter is correctly in position
before use.
Nozzle / Accessories (Fig. L, M)
Figure l - A crevice tool
•
can be extended as shown in Figure l by pulling the
extension piece until it locks into position.
8
• To store the crevice tool
stopping rib
the nozzle until it locks into position.
Fig. K1
4 and filters can be washed in warm soapy
4
6 is built into the nozzle and
6 into the nozzle press the
12 and then push the crevice tool
English
6 into
5