Taurus ALPATEC MG 15 DIGITAL Manual página 10

bags, polystyrene or cables within the reach of
children.
- During transportation, the tilt angle of the
appliance must not exceed 45 °. Do not locate
the appliance upside down as this may damage
the compressor.
- Do not remove the appliance's support legs
- Place the appliance on a flat, stable surface and
away from any heat source.
- The appliance requires proper ventilation in
order to operate correctly. Leave a free space of
15 cm around the appliance.
- Do not obstruct the opening of the door of the
appliance.
- The socket should be easily accessible in order
to be able to quickly disconnect the appliance in
case of an emergency.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has been
removed.
- Before using the product for the first time, clean
the parts that will come into contact with food in
the manner described in the cleaning section.
- It is recommended that you wait for a minimum
of 2 hours after having installed the appliance
before you use it for the first time, leaving the
front cover open.
- Prepare the appliance according to the function
you wish to use:
FILLING WITH WATER:
- You must fill the water compartment before
turning on the appliance.
- Extract the receptacle from its place.
- Fill the compartment with cold water.
- Fill the receptacle taking care to observe the
MAX and MIN level.
- Put the container back onto its place.
USE:
- Ensure that the electronic connector is properly
attached to the appliance.
- Fill the appliance with water observing the maxi-
mum level. Do not place any liquid other than
drinking water in the tank.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off switch
(G).
- Turn the appliance on, by using the on button (1).
- The processing time is approximately 7-12
minutes (depending on water temperature and
room temperature). Caution: The ice cubes
produced may be small and irregular during the
first 3 cycles.
- Once the ice cubes have been processed, the
excess water will drain into the water tank and
the cubes will fall onto the ice tray (B).
- Caution: the cubes may not be fully transpa-
rent, due to the air entering during processing
development but this does not alter the quality
of the cubes.
- When the water tank is empty, the «Tank emp-
ty» light (4) will light up in white and a beep will
sound for a few seconds.
- Turn off the appliance.
- Fill tank while observing the maximum level.
- Wait 3 minutes before running the appliance again.
- When the ice cube tray is full, the «Tray full»
light (3) will light up and several beeps will
sound.
- Drain the ice cube tray with the help of the
spoon supplied with the appliance.
- Never leave the ice tray full while the appliance
is in use.
- To completely empty the water tank, open the
drain plug (E) located inside the tank, ensuring
that there is a container underneath the applian-
ce. Once the tank is emptied, replace the plug
(E) in the tank.
SETTING THE TIME
- Press the Time button (6) to set the device time
- Press Press to reach the desired time
- Press the Time button to set the minutes of thE
device
- Press SET to reach the desired minutes
TIMER FUNCTION
- Press the timer function button to set the on / off
time as desired.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- After use, press the stop button to turn off the
appliance.
- Turn the appliance off, using the on/off switch.
- Unplug the appliance from the mains.
- Remove the water from the inside of the appliance.
- Drain and dry the water tank before storing the
appliance if you are not going to use it for an
extended period of time.
- Clean the appliance.