Publicidad
Idiomas disponibles
Idiomas disponibles
Wool Ingestion Shields (Fig. 1, 2)
The wool ingestion shields (I) are designed to reduce the amount of
wool, dust, and debris that gets ingested by the motor during normal
use. The goal of the ingestion shields is to improve durability as
compared to a unit without the ingestion shields.
Each ingestion shield can be easily removed for cleaning by removing
the mounting screw (J), followed by sliding the shield back towards
the trigger end of the tool and then lifting it off.
The wool ingestion shields can be cleaned with soap and water and a
soft bristle brush in the event they get clogged with polish and debris.
Clean the shields as soon as you start to see buildup on the outside.
Your tool may come with a set of wool ingestion shields. The wool
ingestion shields are available at extra cost from your local dealer or
authorized service center.
FIG. 2
Soft Rubber Gear Case Cover (Fig. 1)
The soft rubber gear case cover (H) is designed to eliminate metal
gear case scuffs on painted or polished surfaces.
The soft rubber gear case cover can be removed if required. To take
off the cover, remove the three mounting screws and lift the cover
over the gear case.
Your tool may come with a soft rubber gear case cover. The soft
rubber gear case cover is available at extra cost from your local dealer
or authorized service center.
OPERATION
regulations.
turn tool off and disconnect tool from power source before
making any adjustments or removing/installing attachments
or accessories. Before reconnecting the tool, depress and
release the trigger switch to ensure that the tool is off.
Polishing pads with a diameter of 6", 7" or 9" may be used with the
DWP849X.
Attaching and Removing Polishing Pads
(Fig. 3)
I
allow any loose portion of the polishing bonnet or its attachment
strings to spin freely. Tuck away or trim any loose attachment strings.
Loose and spinning attachment strings can entangle your fingers or
J
snag on the workpiece.
TO ATTACH PAD
TO REMOVE PADS
Turn the pads by hand in the opposite direction from normal rotation
to allow lock button to engage spindle, then unscrew pads in normal
direction for right-hand thread.
35
WARNING: Always observe the safety instructions and applicable
WARNING: To reduce the risk of serious personal injury,
WARNING: To reduce the risk of serious personal injury, do not
1. Attach hook and loop foam or wool pad (K) to hook and loop
backing pad (L), being careful to center the backing pad with the
foam or wool pad.
2. Screw backing pad (L) onto spindle (G), while depressing spindle
lock button (D).
Publicidad
