Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
Troubleshooting Chart
Stop using stapler immediately if any of the following problems occur. Serious personal injury could occur.
Any repairs or replacements must be done by a Qualifi ed Service Person or Authorized Service Center.
Symptom
Air leaking at trigger valve
area.
Air leaking between housing
and nose.
Air leaking between housing
and cap.
Stapler skips driving staple.
Stapler runs slow or has loss
of power.
Staples are jammed in
stapler.
Air leaking at trigger valve
stem.
www.chpower.com
Possible Cause(s)
O-Rings in trigger valve housing are
damaged
1. Loose screws in housing
2. Damaged O-Rings
3. Damage to bumper
1. Loose screws
2. Damaged gasket
1. Worn bumper
2. Dirt in nose piece
3. Dirt or damage prevent staples or pusher
from moving freely in magazine
4. Damaged pusher spring
5. Inadequate air flow to stapler
6. Worn O-Ring on piston or lack of
lubrication
7. Damaged O-Ring on trigger valve
8. Air leaks
9. Cap gasket leaking
1. Stapler not lubricated sufficiently
2. Broken spring in cylinder cap
3. Exhaust port in cap is blocked
1. Guide on driver is worn
2. Staples are not correct size
3. Staples are bent
4. Magazine or nose screws are loose
5. Driver is damaged
6. Staples loaded incorrectly
O-Rings or seals are damaged
Corrective Action
Replace o-rings and check operation of Work
Contact Element (WCE)
1. Tighten screws
2. Replace o-rings
3. Replace bumper
1. Tighten screws
2. Replace gasket
1. Replace bumper
2. Clean drive channel
3. Clean magazine
4. Replace spring
5. Check fitting, hose, or compressor
6. Replace and lubricate o-rings
7. Replace o-rings
8. Tighten screws and fittings
9. Replace gasket
1. Lubricate stapler
2. Replace spring
3. Replace damaged internal parts
1. Replace guide
2. Use only recommended staples
3. Replace with undamaged staples
4. Tighten screws
5. Replace driver
6. Review Loading/Unloading section in this
manual
Replace o-rings or seals
8
Publicidad
