Weber S-420 Guia Del Propietario página 28

28
OPERATING THE HANDLE LIGHT
The Weber Grill Out™ Handle Light has a built-in "Tilt Sensor." With the power button
(a) activated, the light will come on when the grill lid is open. The light will turn off when
the lid is closed. For daytime use, deactivate the sensor by pressing power button (a).
PROBLEM
Weber Grill Out ™ Handle
Light does not light.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
®
site. Log onto www.weber.com
PROBLEM
Rotisserie burner does not light.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
PROBLEM
Side Burner does not light.
Flame is low in "HI" position
Push button ignition does not work.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web
®
site. Log onto www.weber.com
All manuals and user guides at all-guides.com
OPERATING INSTRUCTIONS
HANDLE LIGHT TROUBLESHOOTING
Are the batteries old?
Are the batteries installed correctly?
Is the lid in the up position with the power button ON?
™
Is the Weber Grill Out Handle Light activated?
Is the Weber Grill Out ™ Handle Light positioned correctly on the handle?
.
ROTISSERIE TROUBLESHOOTING
CHECK
Did you hold the burner control knob in and
hold in for 20 seconds until after burner
ignited?
Did you wait to see the entire ceramic surface
become alight before counting 20 seconds?
Did you repeatedly use the snap ignition until
the burner ignited?
Does the igniter work (Do you see a spark
when you repeatedly use the snap igniter?
® .
SIDE BURNER TROUBLESHOOTING
Is gas supply off?
Is the fuel hose bent or kinked?
Does burner light with a match?
.
CHECK
Try to relight burner by holding burner control knob in and continue holding in until
20 seconds after burner has ignited.
When relighting burner by holding burner control knob in, wait to see the entire
ceramic surface become alight before counting 20 seconds?
After waiting five minutes for gas to clear, try repeatedly using the snap igniter until
the burner ignites (refer to "Lighting the Rotisserie Burner").
Try manually lighting the burner (refer to "Lighting the Rotisserie Burner"). Call
customer service.
CHECK
CURE
Replace batteries.
See assembly illustration.
Light will activate when lid is open.
Press the power button.
Adjust position (See assembly illustration).
CURE
CURE
Turn supply on.
Straighten hose.
If match lights burner, check igniter (see below).
WWW.WEBER.COM
®