LG WM3470HVA Manual De Propietario página 15

Connecting the drain line
Secure the drain hose in place to prevent moving and leaking.
NOTE
The drain hose should be properly secured. Failure to
y
properly secure the drain hose can result in flooding
and malfunction.
Total height of the house end should not exceed 96
y
inches (244.8 cm) from the bottom of the washer.
The drain must be installed in accordance with any
y
applicable local codes and regulations.
Make sure that the water lines are not stretched,
y
pinched, crushed, or kinked.
Using a standpipe
1
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm) from
the end of the drain hose. If the drain hose is extended
more than 4 inches (10 cm) beyond the end of the
elbow bracket, mold or microorganisms could spread to
the inside of the washer.
Elbow bracket
2
Insert the end of the drain hose into the standpipe.
3
Use a tie strap to secure the drain hose in place.
No more than
4 inches (10 cm)
Elbow Bracket
Drain Hose
INSTALLATION INSTRUCTIONS
Using a laundry tub
1
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm) from
the end of the drain hose. If the drain hose is extended
more than 4 inches (10 cm) beyond the end of the
elbow bracket, mold, or microorganisms could spread to
the inside of the washer.
Elbow bracket
2
Hang the end of the drain hose over the side of the
laundry tub.
Drain Hose
3
Use a tie strap to secure the drain hose in place.
No more than
4 inches (10 cm)
Elbow Bracket
15