Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4. OPERATION
Adjusting the gears (Fig.A)
Never switch gears when the motor is
running, this will damage your machine.
Never put switch in the middle between both
positions, this will damage your machine.
The machine has 2 drill speeds, which can be
adjusted by sliding the gear switch (8) forward
or backwards. The number on the gear switch (8)
shows which position is chosen.
• Position 1: For slow drilling, large drilling dia-
meter or screw driving. The machine has high
power at a low speed.
• Position 2: For fast drilling or small drilling
diameter.
Adjusting the direction of rotation (Fig. A)
• Set the direction switch (9) to position
order to drive screws or to use it for drilling.
• Set the direction switch (9) to position
order to remove screws.
Switching the machine on and off (Fig. A)
The on/off switch (5) is used for activating the
machine and adjusting rotation speed.
• Pressing the on/off switch (5) will activate the
machine, the further the switch is being pushed,
the faster the drill will turn.
• Releasing the on/off switch (5) will stop the
machine.
• Move the direction reversing switch (9) to the
middle position to lock the movement of the on/
off switch.
Adjusting the torque (Fig. A)
The machine has 21 different torque settings and a
special drill mode to set the power being transmit-
ted to the chuck. By rotating the torque adjustment
ring (6), screws can be driven to a predetermined
depth, which is ideal for repetitive work. The higher
the number, the more torque will be transmitted.
• Select a low setting for small screws or soft
work material.
• Select a high setting for large screws, hard
work materials and when removing screws.
• You should preferably choose a setting as
low as possible when driving screws. Select
a higher setting if the motor slips before the
8
screw is fully tightened.
• For drilling, turn the torque adjustment ring (6)
to the setting for drilling (
it counterclockwise.
Ensure that the direction switch (9) is
always set to
The machine is equipped with electronic
overload protection function. When the
machine gets overloaded it will shut down
automatically. When this happens, please
wait for a few seconds to let the overload
protection reset itself.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
in
Clean the machine casings regularly with a soft
in
cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Re-
move very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/
EC for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
) by fully turning
during drilling.
WWW.VONROC.COM
Publicidad
