Publicidad
Idiomas disponibles
Idiomas disponibles
Drain
4. Remove the plunger, flange and
gasket from the drain assembly by
unfastening the flange and pulling
these parts from the drain.
Insert the drain body up thorugh
the drain hole from below the
lavatory. If necessary, turn the nut
and push the washer and gasket
(thick) down to allow for clearance.
While holding the drain body in
place, fasten the flange to the
drain body from the top. Ensure
that the gasket is between the
flange and the lavatory as shown.
Once the flange is fully seated,
turn the nut below the lavatory up
until a good seal is formed. Do
NOT overtighten!
Reinsert the plunger if needed.
INSTALLATION PROCEDURE
Plunger
Flange
Gasket
Gasket
(thick)
Washer
Nut
Body
Tailpiece
5
Lever Hole
Publicidad
